Guide to Installing Ram Memory

[Sunite]

Guide to Installing Ram Memory

     

        At this point it will serve little purpose to become too deeply involved in the technical jargon of Memory modules, such as Dimms, Simms, Dram and SDRam.   Suffice to say for our purposes, all ram modules fit into memory slots on the motherboard.  486 motherboards use either 30pin simms or 72 pin simms.  Pentium motherboards require at least 72pin simms or 168pin Dimm SDram modules.

        30pin Simm

        found on older 386/486 motherboards

        72pin Simm

        found on later 486 systems/early Pentium systems

        168pin Dimm

        latest version of Ram Memory, often called:
        PC100 and SDRam

         

        The ram slots are typically easy to insert and uninstall memory.   Memory modules fit in only one direction, with the Simms note the small cut on one side of the module, it corresponds with a tab in the memory holder.  In using Dimms, 168pin ram, they have a distinctive pattern of three areas on the bottom of the module that must be aligned in order for the module to fit into the holder.  Once a Dimm is in place the side clamps lock into place.  This is the same with Simm modules, the small clips that hold them in place will lock once the module is properly installed.

        On rare occasions the bottom of the module will not make good contact with the holder.  You can remove any tarnish or other coatings that infringe upon good contact with the eraser of a pencil or rub them with a small amount of alcohol. 

        INSTALLATION OF RAM MODULES
        Simms:

        When installing SIMMs, most manufacturers require the module to be inserted at a 45 degree angle, then "snapped" forward to the correct position. Most Pentium systems require matched pairs of modules.

     

        Dimms (SDRam):

        Unlike SIMM installation, DIMMs may be "snapped" directly into the socket. Some DIMM sockets have minor physical differences. If your module doesn't seem to fit, please do not force it into the socket...  attempt to return the module for one that fits your motherboard.

         

        Another issue that occurs is the use of mis-matched ram.  In the case of Pentium or better motherboards and using Simms, the simm must be installed two at a time, matched pairs of ram.

        If in fact the memory holders on the motherboard can become damaged or unable to properly seat memory in rare instances.  The only hope for such problems is replacing the motherboard.