Interior Gateway Routing Protocol (IGRP) Configuration.

[Sunite]

Interior Gateway Routing Protocol (IGRP) Configuration.






 
IGRP Configuration


RouterA#show ip route

Gateway of last resort is not set

C         1.0.0.0/8 is directly connected, serial0/1

C         3.0.0.0/8 is directly connected, serial0/0

C         192.168.1.0/24 is directly connected, loopback0



Configure igrp on Router A

RouterA#configure terminal

Enter configuration commands, one per line. End with Cntl/z

RouterA#(config)#router igrp 10

RouterA#(config-router)#network 1.0.0.0

RouterA#(config-router)#network 3.0.0.0

RouterA#(config-router)#network 192.168.1.0

RouterA#(config-router)#exit

RouterA#(config)#



Now verify these configuration on router A with command us under:

RouterA#show ip route

To check the routing protocol with this command.

RouterA#show ip protocols

RouterB#show ip route

Gateway of last resort is not set

C         1.0.0.0/8 is directly connected, serial0/1

C         2.0.0.0/8 is directly connected, serial0/0

C         192.168.2.0/24 is directly connected, loopback0

Configure igrp on Router B

RouterB#configure terminal

RouterB#(config)#router igrp 10

RouterB#(config-router)#network 1.0.0.0

RouterB#(config-router)#network 2.0.0.0

RouterB#(config-router)#network 192.168.2.0

RouterB#(config-router)#exit

RouterB#(config)#



Now verify these configuration on router B with command us under:

RouterB#show ip route

RouterC#show ip route

Gateway of last resort is not set

C         2.0.0.0/8 is directly connected, serial1

C         3.0.0.0/8 is directly connected, serial0

C         192.168.3.0/24 is directly connected, loopback0

Configure igrp on Router C

RouterC#configure terminal

RouterC#(config)#router igrp 10

RouterC#(config-router)#network 2.0.0.0

RouterC#(config-router)#network 3.0.0.0

RouterC#(config-router)#network 192.168.3.0

RouterC#(config-router)#exit

RouterC#(config)#

Now verify these configuration on router C with command us under:

RouterC#show ip route